Electrical Bus

End feed unit: Power comes through cable & feeded in this unit. The front side is connected with the standard legth of 3m(siemens, BBI, EAE),3.05 (Powerduct) or 4m (Graziadio, gersan) bbt. It's dimension varies on current ratings.
















Flexible elbow : This is used as elbow for low rating (25A -40A)bus bar system. The cable is normally 0.5m length.

















Standard length : This in orginally main Busbar Trunking System. It's of two types. One is feeder length has no plug in point. Another is straight length. The length is normally 3m/3.05m/4m varies by brand. If it requires special size then it would very from minimum 400mm -2900m. For 4m standard length small piece is minimum 400mm-1.9m & large size is 1.91m-2.99m.
















Horizontal elbow: It is very important for turn to angle. Standard 90 deg. If required specific degree angle then it need to specially ordered.

Centre feed unit: This part feeds power and delivered it two side same time.

Tap off box: This is tap of box. If required power then tapped it with the plug in point with a circuit breaker.

T Elbow: It is a special elbow.Feed power from one side & delivered it in two sides.

End cap: It should connect be connect at the end of power bbt.

Fixing hanger: It is use for hanging the busbar trunking system.